Occurs when the designated "start" and "stop" bits are not valid. The following class constants can be used to test the LastErrorCode value. The following class constants can be use to set the number of bits using the Bits property. The following class constants can be used to get or set the number of stop bits using the Stop property. The following class constants can be used to get or set the parity using the Parity property. The following class constants can be used to determine line state changes. On Linux, some non-standard baud rates are possible to achieve by using the Setserial system call and setting your baud rate to a special value. If the driver supports the passed baud rate, then it is set (or approximated). On macOS, the system supports arbitrary baud rates by passing the request along to the driver. Setting nonstandard baud rates is supported only on Windows and macOS and above. To get the baud rate, compare the value of the Baud property to the constants in this table. To set the Baud rate, assign the desired class constant to the Baud property. Serial controls are used to perform serial communications.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |